Troubleshooting process on how to fix the issue on Xbox 360 overheating

Troubleshooting process on how to fix the issue on Xbox 360 overheating

Troubleshooting process on how to fix the issue

In recent years, I have experimented with and documented many Xboxes 360 consoles. From the experience I have, I have known a few best methods and steps to use to sort the problem caused by overheating of the Xbox console. This aids the problem of overheating affecting hardware failure.

In this article, I will show you my Simple steps that have troubleshoot over fifty Xboxes until now and all of them worked.

The RRoD overheating results from too much dirt and is affected by the heat cracking and melting of the GPU or CPU from the motherboard system.E74 is affected by the HANA/ANA chip melting the in the motherboard. My steps will keep away overheating and solve the most RRoD and E74 errors.

Be warnedThis method will void your warranty if you currently have one.RequirementsPenniesElectrical tapesThermal pasteScrewdrivers and Torx (measurement of 10 and 8 respectively)Superglue (not a must)StepsOpening the boxThere is a lot of information in this step but let me tire you up.

So, I will spare myself and head directly to the problem procedure. What you have to do is strip every component. Remove the pads from the Ram slots in the motherboard system.Apply the troubleshoot The pennies available will help us when we make them into heat absorbers and heat conductors.

I assure you that the pennies you have are far better than the pads Microsoft provides for our systems. The pennies also help to prevent and return the flexing in the motherboard as they are solid.Solve and prevent RRoDEnclose four sets of two pennies each in the electrical tape you have.Apply a small layer of thermal paste to the dark RAM chips available.

Place them where the old pads were initially available.Place the pennies on the section where the old pads were located. You can decide to apply super glue to it for sticking purposes. This helps when you put the case altogether.Put the thermal paste on the chips below the fans that you eliminated earlier. This will act as a good conductor of heat. It works best. Place the fans in their positions and the x-clamps.

In case of the RRoD issue reassemble your Xbox 360 console.

Tighten the parts with a screw and try it before completing the setup. If it does now tighten the screws more to your desired position.Solve and prevent E74To solve the issues with the E74 error, apply pressure to the HANA/ANA chip.

Place another stack of peenies in the white heat space. Ensure it is enough.

Put the DVD drive to its position in the case and create another penny of the stack to stick the space needed.Place the case in its position correctly and tighten all the bolts using the screw.

The pennies available will exert force on the HANA/ANA chip to make 360 runs.

For about thirty minutes of the Xbox 360 active time, it should fix this issue for good. The force created by the pennies exerting down on the chip ensures that if the soldering material overheats to its maximum, it lowers the chip to its moderate level.When you are done fixing everything the Xbox console should be back to its glory days.


Franklin Obibo

48 Blog posts

Comments